|
||||||||||||||||||||||||||||||||||||||||||
|
||||||||||||||||||||||||||||||||||||||||||
| OpticLink LS16 Back to Adapters / Extenders Back to Manufacturers |
Key features
- LVDS RS-644 video interface (optional RS-422)
- max 16 bit per pixel
- up to 55MHz pixel clock (optional 62.5 MHz)
- available in two models:
- mm: multi mode fiber, maximum length: 500 meter
- sm: single mode fiber, maximum length: 10 kilometer (optional: 40 to 60 km)
- transmission of:
- video data and synchronisation
- two RS-232 channels
- control signals
- two units:
- L2F converts LVDS data to fiber
- F2L converts fiber back to digital video
- unit L2F connects directly to picassoTM PCI-FI and cPCI-FI framegrabber
- fiber link benefits:
- does not radiate
- is not susceptible of electromagnetic interference
- difficult to tap (secure connection)
- no grounding problems
General
The opticlinkTM LS-16 offers long haul video transmission over fiber optics cable. This interface can be used for transmission of LVDS video data up to about 40 to 60 kilometer without optical repeaters.
It is a transparent interface, so it is compatible with almost all available LVDS cameras and third party framegrabbers. The opticlinkTM transmits not only video data from camera to framegrabber. Two bidirectional RS-232 channels and camera control signals from framegrabber to camera are transmitted too.
| Model | Opticlink(TM) LS-16 |
| Fiber type | multi mode or single mode |
| Max fiber length | multi mode: 500 meter single mode: 10 kilometer (optional: up to about 40 to 60 km) |
| LVDS interface | LVDS RS-644 (optional RS-422) |
| LVDS connector | AIA-standard 68-pin female |
| RS-232 channels | 2, full duplex |
| RS-232 connectors | 2x sub-D9 |
| Power connector | 4-pins subminiature round male connector |
| Dimensions (l x wx h) | 160 x 105 x 44 mm |
| Supply voltage | 5.5 V to 6.5 V |
| Power consumption | 7.8 W typical |
| Operating temperature | 0 C to 70 C |
|
If you like this page, please recommend and share it. |
||
| More | ||
